4
PRODUCT DESCRIPTION
The Aoyue Int9378 Pro-Series is a high performance multi-tool
station having up to 75 watts of heating power. It can be equipped
with a variety of tools such as a micro tweezer, a sculpting tool, a
WQ-composite Iron, T-series soldering Iron, LED soldering iron.
Each tool is intelligently recognized by the station and quickly set the
appropriate settings for the tool. All tools feature quick heating
ceramic heater for fast response and heat recovery.
Intelligent functions and features are available such as digital
offset, auto wake function, auto sleep function, auto tool
regocnition, System lock-out , quick jump, Temperature Scale
selection, LED lamp control and auto sleep.
PACKAGE INCLUSION
1 unit Int9378 Pro-Series Main Station
1 pc. Soldering Iron
1 pc. 2660 Soldering Iron Stand**
1 pc. Power Cord
1 pc. Instruction Manual
** Kindly refer to soldering iron stand installation on page 2 for parts and instructions.
13
CARE AND MAINTENANCE
Tip Temperature :
High temperature shortens tip life and may cause thermal shock to
components. Always use the lowest possible temperature when
soldering. Standard temperature settings are 350 to 400 degrees
Celsius.
Cleaning :
Always clean the soldering tip before use to remove any residual
solder or flux adhering to it. Use a clean and moist cleaning sponge.
Contaminants on the tip
have many detrimental effects including
reduced heat conductivity which contribute to poor soldering
performance.
After usage:
Always clean the tip and coat it with fresh solder after use. This
guards against oxidation and pro-longs tip life.
System Care:
Never allow the unit to stay idle at high temperature for extended
periods. Utilize the automated sleep feature to conserve energy, pro-
long tip and heating element life. If unit will not be used for long
periods it is advised to power down the unit and unplug from the
mains.
Inspecting and cleaning the tip:
◆
Set the temperature to 250
o
C.
◆
When the temperature stabilizes, clean the tip and check its
condition. If the tip is badly worn or deformed, replace it.
◆
If the solder plated part of the tip is covered with black oxide, apply
fresh solder containing flux and clean the tip again. Repeat until all
the oxide is removed then coat the tip with fresh solder.
◆
Never file the tip to remove oxide.
◆
Remaining oxides such as the yellow discoloration on the tip shaft
can be removed with isopropyl alcohol.
