Aosom 370-218V80, Assembly Instruction Manual

Page: 5 / 21

5
1
2
Pairing instructions
1. Turn the car on, then hold the pairing button until the speed indicator stays lit.
2. Stop holding the pairing button – the speed indicator will turn off.
3. If the speed indicator turns on again, the pairing is successful; if not, please repeat
steps 1 and 2.
4.Once pairing is successful, you do not to pair again in the future.
Remote control battery installation
Open the back cover of the remote control, then insert two AAA batteries. Pay attention
to the polarity. Close the back cover and tighten the screws when the LED is on,
indicating the battery is installed properly.
When the LED light dims or blinks, the batteries need replacing.
1. Iron handlebar assembly
Installation
1.Insert iron handlebar into its position on the car body, following the arrow.
2.Use two M4X30 flat screws to tighten. Do the same for the other side.
3.Flip the car and use one M4X30 flat screw to tighten. Do the same for the other side.
1 2 3
Bottom
2. Steering plate assembly
1. Insert the direction lever
into the steering plate hole,
then add one small washer
to the lever. Insert one
cotter pin into the lever hole
to tighten.
2. Tighten the steering plate,
using two M6X12 screws
and two M6 nuts.