Specification
-- E-10 --
We recommend that you install the CD-ROM on the Secondary IDE
channel as the master device (MA), and the CD-R/RW on the Secondary
IDE channel as the slave device (SL). Please follow the steps below to
fulfill this arrangement.
y
First make sure that your Secondary IDE cable has two ports available for two
y
IDE devices. If not, ask your main board vendor or purchase one from computer
hardware stores.
y
If the CD-ROM drive was installed in the Primary IDE channel, disconnect it
from the Primary IDE cable.
y
Adjust the Device Configuration Jumper of the CD-ROM drive to “Master” (MA)
position.
y
Adjust the Device Configuration Jumper of the CD-R/RW to “Slave” (SL)
position.
4. From your main board, find out the 40-pin Secondary IDE interface cable. Then
connect them to your CD-R/RW. Please do notice that the color edge of the IDE
cable must be aligned with PIN 1 of the IDE controller.
Pin1
