Potentially Explosive Atmospheres
Turn off your electronic device when in any area with potentially explosive
atmosphere. It is rare, but your electronic device could generate sparks. Sparks in
such areas could cause an explosion or fire resulting in bodily injury or even death.
Areas with a potentially explosive atmosphere are often, but not always, clearly
marked. They include fueling areas, such as petrol station, below deck on boats, fuel
or chemical transfer or storage facilities, and areas where the air contains chemicals
or particles, such as grain, dust, or metal powders.
Power Supply
The gateway must be supplied by a limited power source according to EN 60950-1.
Connect your power supply only to designated power-sources as marked on
the product.
Make sure all cords and cable are positioned so that they will not be stepped
on, tripped over or otherwise subject to damage or stress.
To reduce risk of electric shock, unplug the unit from any power source before
attempting to clean it.
Troubleshooting
This section lists some problems that you might encounter while using your Anybus
Wireless Bridge Serial - Bluetooth.
1. I cannot connect. The data I send to the gateway does not arrive at the remote
device.
o
Make sure that you have connected power to your gateway. The LED
indicator should emit a green light when powered up, being ready to
send and receive data.
o
Your gateway is not configured to use the same serial settings (e.g.
baud rate) as your host system. Use the Toolbox to set the correct baud
rate.
o
You have configured your gateway to act as a client but you have not
selected a server device to connect to. Select a server device using the
Toolbox.
o
Your gateway is too far away from the selected server device. Move the
gateway closer to the server device.
o
You are not using the correct Bluetooth profile. Your gateway must be
configured to use the same profile as the device you want to
communicate with.
o
The remote device is not in connectable mode. If the server device is
another gateway use the Toolbox to set the device in connectable
mode. If the device is another Bluetooth device, consult the manual for
that device to set it in connectable mode.
o
Make sure that the gateway is in transparent data mode (green light).
Make sure that the gateway is not in configuration mode (orange light).
