User Manual
7
1 Notice For User
1.1 Security Considerations
Please read carefully before using the manual:
1. Please read it carefully first of all;
2. Don‗t install the terminal under direct light, humid, dusty or sooty environment;
3. Don‗t install the terminal near the magnetic field;
4. Don‗t install the terminal near the calefaction device;
5. Don‗t sprinkle the liquid (water, drink, chemistry) on the terminal;
6. Always keep the surface of the terminal clean;
7. Clear the terminal by towel when there is water on the surface;
8. Don‗t break the terminal;
9. Don‗t press two keys at the same time;
10. Don‗t take down, repair or change the terminal without authorization;
11. Don‗t allow children to touch the terminal;
12. This terminal is only used for fingerprint verification, don't use it for other purposes;
13. If in doubt, please contact the local distributor.
1.2 Illustration for Pressing Fingerprint
Correct method:
Place the center of the finger on the center of scanner window.
Wrong method:
Too less valid area Too left Too right Defluxion Too down
Note:
1. It is better for each user to register two finger prints in case of one finger can
‘t work.
2. Place finger flat and make sure the center of the finger is on the center of scanner window and
press a little hard on scanner so it can scan as large finger area as possible to extract enough minutia.
3. Keep the angle and direction of finger the same each time placing on scanner.
4. If your finger has sweat or water, please dry it first and then register the finger.
5. If your finger is too dry, make it a little wet or touch the forehead to increase the wetness of the
finger, press a little hard on scanner.
（
The dry finger can cause the finger image not coming out clear
enough.
6. Avoid the callus, peeling, or injury of the finger to ensure the register and identification successful.
7. You can register the thumb first, and then index finger or middle finger to increase the precision.