Ⅵ
. Install the Front panel Assembly
1.
Install a
Silica gel backing plate
on the f
Front panel Assembly
(moisture proof / waterproof). As shown in
Figure 12
.
2.
Stretch the
Spring Bolt
back to the
Lock Body
and pull the
Connecting Wire
out of the hole at the bottom of the
Lock Body
.
3.
Install the
Front panel Assembly
into the matching
Hole Slot
on the door. (There are three holes on the
Lock
Body
, as shown in the preceding figure. The cylinder on the fore plate composition must be pulled out from the
crossshaped hole of the
Lock Body
and the
Locking Bar
must be vertical to the ground.), as shown in
Figure 13
.
4.
Install the
Back Lining Plate
to the mapping
Hole Slot
. Pull the
Connecting Wire
out of the
Ovalshaped Hole
of the
Back Lining Plate
(As shown in
Figure 14)
and fix the
Back Lining Plate
and
Front panel Assembly
using
a screwdriver, as shown in
Figure 15
.
3.
After the procedure is completed, fix the
Lock Body
using a screwdriver, as shown in
Figure 6
. Insert the
screwdriver into the crossshaped hole of the
Lock Body
. When you rotate the cylinder clockwise, it springs out
automatically, as shown in
Figure 7
. When you rotate the cylinder counterclockwise, it springs back automatically,
as shown in
Figure 8
.
Ⅴ
. Confirm the length of Locking Bar
1.
Install the
Front panel Assembly
of the lock onto the door (Please see
. Install the Front panel Assembly
). As
shown in
Figure 9
:
2.
Check whether the
Locking Bar
is too long. If yes, take the
Front panel Assembly
off and cut away the excess
part of the
Locking Bar
(see
Method for Cutting Locking Bar
). As shown in
Figure 10
.
Method for cutting Locking Bar
: Suppose that the part of the
Locking Bar
that stretches out of the
Hole Slot
on
the door is
CD
, as shown in
Figure 11
. Cut away the
Locking Bar
from A to ensure that the
Locking Bar
does not
stretch out of the
Hole Slot
.
5
6
Figure 6
Figure 7
Figure 8
Figure 9
Figure 10
Figure 11
Figure 12
Figure 13
Figure 14
Figure 15
Front panel Assembly
Silica gel backing plate
