P/N 1011512 Rev A 10/18
5
Installation
Unpacking
1.
Remove unit and all packing materi-
als from shipping carton.
2.
Open the large box. Remove all
packing materials and protective
coverings from the unit and parts.
NOTICE:
If any parts are missing or
damaged, contact Antunes
Customer Service IMMEDI-
ATELY at +1-877-392-7856 (toll
free).
3.
Place the unit where it will be used.
4.
Wash, rinse, and sanitize hose con-
nection manifold, the cup mounting
platform, the steam nozzle, and the
cup at the sink. Wipe all surfaces of
the unit with a clean, sanitized towel.
NOTICE:
Do NOT use a dripping wet
cloth. Wring out before use.
5.
Install the hose connection manifold
by sliding its flanges under the mani
-
fold retainer (see Figure 1).
6.
Connect the drain tube to the hose
connection manifold (see Figure 1.)
7.
Snap the cup mounting platform
into the four rectangular holes in
underside of the steamer housing as
shown in Figure 2.
8.
Insert the steam nozzle through
the opening in the cup mounting
platform and into the bottom of the
hose connection manifold and twist it
a half-turn.
9.
The cup attaches to the cup mount-
ing platform by twisting it a quarter-
turn.
10.
Connect the Water Pressure Regula-
tor to the cold water line.
11.
Direct the drain hose to a drain. Al-
low a 2 inch gap between the drain
hose and the drain. Do NOT allow
the drain hose to be submerged.
Equipment Setup
When placing the unit into service, pay
attention to the following guidelines.
y
Make sure power is off and the
unit is at room temperature.
y
Do NOT block or cover any
openings on the unit.
y
Do NOT immerse cord
or plug in water.
y
Keep cord away from
heated surfaces.
y
Do NOT allow cord to hang
over edge of table or counter.
Cup mounting platform
Steam nozzle
Cup
Steamer housing
y
Place unit on a sturdy, level
table or work surface.
y
Make sure there is at least a 3 inch
gap between walls and the unit.
Do not connect to a circuit operating at
more than 150 volts to ground.
y
Install the steamer with adequate
backflow protection complying
with all applicable codes.
Verify that the line voltage corresponds to
the voltage on the unit specification label.
Touchscreen
This unit is equipped with a touchscreen
that uses a graphical user interface or
GUI that acts as the main control for the
unit.
Treat the GUI interface with the same
care as you would any touchscreen
device. Do not use tools or objects on the
GUI. Do not scratch or damage the GUI.
Hose
connection
manifold
Manifold retainer
Drain tube
Figure 1.
Installing the hose connection manifold
Figure 2. Components
