HRS SERIES
8
P/N 1011556 Rev A 08/19
®
Installation
Mounting the System
NOTE:
Use caution when lifting and mounting the system.
The system MUST be mounted using the provided
Mounting Bracket.
The system comes with a Mounting Bracket. When mounting
the system, pay attention to the following guidelines:
y
Allow sufficient access for cartridge replacement.
The system should be mounted with 3
inches to the botton of the system.
y
DO NOT mount the system above an electrical outlet.
y
Mount the system before the consumable water
filtration processes.
y
Plan your mounting accordingly.
1.
Secure the Mounting Bracket and Standoff (provided) into
wall studs with heavy duty hardware capable of supporting
at least 25 lbs. (Mounting hardware not supplied)
2.
With the mounting bracket securely mounted to the wall,
insert the filter head on the wall bracket noting the inlet and
outlet and directional arrow on the head (Figure 5).
3.
Attach the adaptor to the filter head inlet, finger tight only.
Do not use pipe tape or dope on the threads, and do not
use a wrench (Figure 6).
4.
Attach the Flush Valve to the outlet port of the filter head,
finger tight only. Do not use pipe tape or dope on the
threads, and do not use a wrench (Figure 6).
5.
Attach the hose supplied with the Flush Valve to the valve
outlet.
6.
Attach the Water Meter (if available) to the outlet of the
Flush Valve, finger tight only.
7.
Attach an adaptor to the outlet of the Water Meter (if
available), finger tight only.
8.
Connect the inlet to the water supply. It is recommended
that an inlet shut-off valve (not provided) be installed ahead
of the filter system.
9.
Connect the outlet of the filter system to the water using
equipment.
10.
Unwrap the filter cartridge and remove the protective cap.
Mark the date of installation on the filter cartridge label.
11.
Install the filter cartridge into the filter head. When viewed
from above the head, turn the cartridge counter-clockwise
into the thread of the filter head. The cartridge will come to
a stop when fully installed.
12.
Open the inlet valve and let water enter the filter head and
cartridge.
13.
Open the Flush Valve and let water out the Flush Valve
hose into a bucket. Flush at least 4 gallons (15 L), until the
water outler is clear and free of air bubbles. Do not
consume or use this flush water.
CAUTION
DO NOT use the Rinse Valve for consumable water.
14.
Close the Flush Valve and look for leaks at all fittings.
Figure 5. Attaching the Filter Head to Wall Bracket
Filter Head
Wall Bracket
Standoff
Water Meter
(Optional)
Flush Valve
Flow Direction Arrow
Inlet
Outlet
Hose
Filter Head
Blend Setting
Indicator
Adaptor
Figure 6. Adaptor and Flush Valve Attached
to Filter Head
Figure 7. Filter Head Attached to Water Meter
