HEBT-3V BUN TOASTER
6
P/N 1011328 Rev. I 04/18
McDonald’s
Operating Instructions
The HEBT-3V toasts Crowns, Heels, Clubs, and other
products. Follow these steps to start the HEBT-3V:
1. Turn on the toaster and wait for warm-up to com-
plete.
2. Set the Compression Knob to 4 (recommended).
If further adjustments are required see page 8
under Adjusting Toast Quality. Refer to the figure
on page 7.
3. When the unit reaches operating temperature, the
control panel displays “Ready”.
4. Insert product into the designated area of the Bun
Feeder Assembly with the cut side of the bun fac-
ing towards the front. Toasted product drops into
the Bun Buffer.
OPERATION
Figure 2. HEBT-3V Control Panel and Display
User Mode
User Mode allows an operator to view the toaster set-
tings but does not permit any adjustments.
1. Press and hold the
PROGRAM
button for 5 sec-
onds. After 5 seconds, the display will show the
actual temperature of the Rear Platen.
2. Press the
LIGHTER
button to toggle between
the setpoint and actual temperature of the Rear
Platen Heater.
3. Press the
PROGRAM
button to proceed to the
Front Platen Heater menu. The display shows the
actual temperature of the Front Platen.
4. Press the
LIGHTER
button to toggle between
the setpoint and actual temperature of the Front
Platen.
5. Press the
PROGRAM
button to proceed to the
Motor Menu. The display shows the actual speed
of the motor.
6. Press the
LIGHTER
button to toggle between the
setpoint and actual speed of the Motor.
NOTE: The unit will exit User Mode after 5 seconds
of keypad inactivity.
Manager Mode
Manager Mode allows an operator to view and adjust
the following settings:
• Platen A Temperature
• Platen B Temperature
• Motor Speed
• Temperature Units (Celsius or Fahrenheit)
• Current Selection: 208 or 240 volts
Manager Mode also allows an operator to view (but
not adjust) the Ambient Temperature of the Control
Compartment as well as the number of days of opera-
tion.
1. Turn the unit off.
2. Turn the power on while holding the
PROGRAM
button. Hold the button for 5 seconds until the dis-
play shows “EnA.” Release the button.
3. To adjust the Platen Setpoint Temperature, press
the
LIGHTER
or
DARKER
buttons to reach the
desired temperature.
NOTE: The recommended temperature setting for
the Rear Platen is 271° C (520° F).
Summary of Contents for HEBT-3V
