CHEESE MELTER
10
P/N 1010983 Rev. F 05/19
®
PROGRAMMING
General Information
CYC (Total Cycle Time)
refers to the total amount
of cooking time set for the product.
RATE (Shot Interval Time)
is the time set between
shots of steam during a complete cycle.
SHOT (Steam Shot Time)
is used to adjust the
water volume during each solenoid operation or
shot of steam.
The amount of steam produced by your unit
depends on the amount of water sprayed onto the
steam generator. The generator may flood if the
RATE setting is too low or if the SHOT setting is
too high.
To prevent flooding, increase the RATE to allow
more time for generator heat recovery and
decrease the SHOT to reduce the water volume.
Adjustments should be made to both values to
determine the best settings for your cooking needs.
Factory Settings
The RS-250 is factory programmed for the following
default values:
Programming the RS-250
NOTE: CYC, RATE, and SHOT are sequential
operation per channel for all programming (You
must perform all steps for CYC and RATE to
change SHOT).
NOTE: CYC, RATE, and SHOT are only dis-
played momentarily during the programming
sequence after pressing the Program button.
CYC (Total Cycle Time)
1. Turn the unit on. Allow the unit to preheat for
30 minutes.
NOTE: During preheating, the display flashes
“LOW”. When unit reaches operating tempera-
ture, the display shows “RDY1” or “RDY2” and
the active channel indicator light is lit.
RDY1
CH-1
CH-2
RANGE
CYC
21 secs
24 secs
0 sec to
99 mins 59 secs
RATE
7 secs
7 secs
1 sec to
5 mins 59 secs
SHOT
0.21 secs 0.21 secs 0.10 sec to
2.50 secs
