®
P/N 1010455 Rev. K 10/20
5
Installation
Unpacking
1.
Remove the unit and all packing
materials from the shipping carton.
2.
The unit should come with the items
listed below:
y
Owner’s Manual
y
Inlet Hose Assembly
y
Spatula Assembly (MS-250 only)
y
Drawer Assembly (MS-255 only)
NOTE:
If any parts are missing
or damaged, contact
Antunes Customer Service
IMMEDIATELY at +1-877-392-
7856 (toll free)
3.
Remove all packing materials and
protective
coverings from the unit.
4. MS-250
: Remove and wash the Wire
Trivet, Spatula, Spatula Liner, and
Drip Pan (Figure 1) in soap and wa-
ter. Rinse with clean hot water and
allow to air dry.
5. MS-255
: Remove and wash the
Drawer, Drawer Liner with Rollers,
and Drip Pan (Figure 2) in soap and
water. Rinse with clean hot water
and allow to air dry.
NOTE:
MFG. No. 9100933 does not
use the Drip Pan or Steam
Vent.
6.
Wipe all surfaces of the unit with a
hot, damp cloth.
NOTE:
Do NOT use a dripping wet
cloth. Wring out before use.
7. MS-250 Models
: Assemble the
Guard and Mounting Bolt to the
Spatula (Figure 3). Then install the
Wire Trivet into the side slots on the
Spatula.
8.
Re-install all removed parts.
Equipment Setup
When placing the unit into service, pay
attention to the following guidelines:
y
Make sure power is off and the
unit is at room temperature.
y
Do NOT block or cover any
openings on the unit.
y
Do NOT immerse cord
or plug in water.
y
Keep cord away from
heated surfaces.
y
Do NOT allow cord to hang
over edge of table or counter.
Bolt
Handle
Spatula
Handle Guard
Wire Trivet
Spatula
Wire Trivet
Spatula
Liner
Drip Pan
Figure 1. Washing Parts–MS-250 Only
Drawer
Drip Pan
(Except Mfg. No. 9100933)
Drawer Liner
with Rollers
Figure 2. Washing Parts–MS-255 Only
Figure 3. Assembling Handle–MS-250 Only
