When combining those
connectors
with Faber panels you can build following projects:
Basic constructions can be
expanded
and
connected
in various ways. This is done by the
four holes
located in the middle of the panel
. The holes are thread-less and are used to connect panels side by side,
or are for corner C1 connector.
You need both
bolts
and
nuts
to make such connections.
The panels or the buildings themselves can be interconnected with
stainless steel rods
,
which can also be installed into the holes without a thread using a
nut
on each side. The
stainless steel rod
basically replaces the
panel
.
Some more complex constructions require overlapping of two
connectors
. For example,
T2
over
E1
, or
E1
over
H1
and other combinations. In these cases you will need a wooden
bolt 50
On the below picture is shown how the overlapping of
two connectors
is done:
A
-
bolt 35
,
B
-
bolts 50
,
C
-
washer
.
4