49
7.
ADVANCED SET-UP
continued …
Note:
The On-Screen display is not available for Component Video.
Note:
If you have connected and selected ‘Composite’ for ON-SCREEN OUT and afterwards change it
to ‘S-Video’, the Setup Menu will immediately disappear because doing so has actually
‘disconnected’ the On-Screen display from your TV Monitor. If this has occurred, immediately
press the
4
key (
MASTER CONTROL KNOB
) to return to ‘Composite’. You can also correct this
using the AVM 2 Front Panel keys to enter the Setup Menu – go to DISPLAY / SELECTION TIME
(menu 8), then ON-SCREEN OUT (8.b) and change back to ‘Composite’. (Of course the same would
occur if you were connected to S-Video and changed to Composite.)
(menu 9.c) Selection Time:
After a key is used on either the Front Panel or Remote Control (e.g. Vol, etc.) and the ‘Selection Time’ has
elapsed, the On-Screen displayed text will disappear and the Front Panel display will go dim. You can change
this Selection Time; choose from ‘1 to 30 s’ or ‘Always On’. This selection time also applies to how long
ZONE2, REC or HEADPHONE information remains displayed before returning to MAIN display information.
(menu 9.d) On-Screen Pos’n:
This allows you to position the On-Screen display to reduce the chance of it interfering with the on-screen
display positions of other video components (e.g. Satellite Receiver or a TV Monitor’s own display, etc.).
Choose from: ‘Bottom’, ‘Mid’, or ‘Top’.
(menu 9.e) Z2 Info On MAIN OS:
Lets you select whether or not the On-Screen display will show ZONE2 information whenever ZONE2
adjustments are made. If ZONE2 is set up to use the Remote Control (with an IR repeater, etc. – consult
dealer), you may not want to see ZONE2 adjustment someone is making while you are perhaps watching a
DVD. At other times, when you are making adjustments to ZONE2 in the same room as the AVM 2 you may
want to see the ZONE2 information displayed.
(menu 9.f-i) Front Panel Display Adjustments:
•
Brightness:
Simultaneously adjusts the intensity level of the LCD display and LED indicators. Three
separate adjustments can be made – HI, MED and LOW. Use HI to set the daytime level, MED for
the evening level and LOW for the nighttime level. The DISPLAY key cycles through these settings.
As you make brightness adjustments, the LCD display and LED’s change immediately to allow you
to see the result of the setting.
•
FP Wa k e - u p
: After the Front Panel has dimmed, it may immediately wake-up to a brighter level when
you press any active key (e.g. Vol, etc.). You may choose to have the Front Panel display wake-up at
one brightness level higher than the dimmed level, or at the highest level. Choose ‘1 UP’ or ‘HI’.
DISPLAY /SELECTION TIME Example:
Change the ON-SCREEN OUT to ‘S-Video’.
• Enter the Setup Menu (section 7.1). Go to ‘8. DISPLAY/SELECTION TIME’ and press
SELECT
(
‘Select’
)
.
• Press the
6
(
‘Down’
)
key until you reach “b. ON-SCREEN OUT: Composite”.
• Use the
34
keys (
MASTER CONTROL KNOB
) to change to ‘S-Video’.
• When finished press
65
(
‘Down’
/
‘Up’
)
to go to another Menu Item, or...
• Press the
EXIT
(
‘ B a c k ’
)
key to leave the submenu and return to the Setup Menu.
Summary of Contents for AVM 2
Page 68: ...THE BIG PICTURE FRONT PANEL ...
Page 69: ...THE BIG PICTURE REAR PANEL ...
