Antelope Orion Studio HD, Owner'S Manual

Page: 24 / 32

22
● If you believe there is no sound being received to an input or delivered from an output:
● Check your source. Is there a signal being transmitted form the source?
● Is your source in the correct sample rate for the Orion Studio HD to receive?
● Check what clocking mode you are in. Are you receiving the clock signal from the source?
● Check that the relevant lock light on the control panel of the Orion Studio HD is lit up.
● Try a different cable and another source if available.
● Check the routing on the control panel. Have you routed the signal path correctly?
● If you have routed signals to the routing mixer, check their corresponding fader is up.
● Check the relevant peak meters of the control panel by selecting them in the drop down
menu to see if the relevant signal is being received or is being outputted.
DAW
● What buffer size is your DAW set to?
● If it is significantly low i.e. lower than 128 samples in your buffer size, try increasing it. Try
increasing the buffer size from the Orion Studio HD control panel (Windows Only)
● Have you checked the input and output routing is correct in your DAW?
● Is the Orion Studio HD device selected in the relevant sound card section of the DAW’s
preferences?
If the Orion Studio HD doesn’t show up in you DAW, first try unplugging and plugging back the
USB 3.0 cable, then restarting your Computer and finally re-install the firmware, drivers and
control panel for the Orion Studio HD.