HYDRAULIC CALLIPER TYPE NHCD-1400
Instructions for assembly, adjustment and maintenance
T.D.S.: BC.TDS.00025I
Rev.0.: September - 2012
6. CHANGING THE SPRINGS.
To change the springs proceed as follows (the explanation is given for one of the
brake's semi-callipers, the procedure being the same for the other):
6.1-
Feed the brake at the pressure indicated for each brake in the attached table of
point 1.3 of the instructions.
6.2-
Maintaining the hydraulic pressure, remove the sensors bracket (marked 9).
The process of changing springs is hazardous for the operator
doing it, for which reason Antec warns of the danger and
advises the client to establish a specific risk prevention
protocol for this point.
To change the springs, it is not necessary to dismantle the
semi-calliper from its bracket.
NOTE
9
