HYDRAULIC CALLIPER TYPE NHCD-1400
Instructions for assembly, adjustment and maintenance
T.D.S.: BC.TDS.00025I
Rev.0.: September - 2012
4.1.4
Once this opening has been adjusted lock the adjustment screw (marked 5) using
the nut (marked 19).
4.1.5
The brake must ALWAYS be adjusted when the brake is installed, there is wear
in the lining of 1 mm or the linings are replaced.
4.1.6
At that time the brake, after having cancelled the hydraulic feed, will by the action
of the springs brake with the force shown in the attached table in point 1.3.
4.1.7
Mount the locking backstop (marked 6) with the bolt (marked 38) in the position
shown in the following diagram (storage position of the locking backstop).
NOTE
The airgap must be the same on both sides of the disc.
Otherwise, there may be anomalous forces applied to the
disc and to the brake bracket.
The wider the opening (>1 mm), the less the braking
force and the lifespan of the springs.
6
38
Backstop position
with brake
unlocked. Storage
position.
