Antari S-100II, User Manual, Page: 7 / 32

7
Pin Function
1 Ground
2 Data-
3 Data+
DMX Control
a) Connect the DMX cord to the DMX-IN socket on the rear of the machine.
b) Test the system by activating the snow system's selected DMX channel. When the
channel value is increased the snow machine should produce snow at a steadily
increasing rate. The unit is OFF when a value between 0-5 is selected. It will reach 100%
output once the channel is set to 255.
DMX Protokoll
DMX VALUE
0-5 OFF
6-255 ON
c) Addressing:
Each device occupies 1 channel. To ensure that the control signals are properly directed
to each device they require addressing. This is to be adjusted for every single device by
changing the DIP-switches as set out in the table below.
The starting address is defined as the first channel from which the device will respond to
the controller. Please make sure that you do not have any overlapping channels in order
to control each device correctly and independently from any other fixture on the DMX
data link. If two, three or more devices are addressed similarly, they will work similarly.
Occupation of the DIP-switches
Setting the
DMX-Starting
Address
DIP-Switch
NO.
1 2 3 4 5 6 7 8 9