2
♦
Always allow your ANTARI Fog Machine to cool down before attempting to clean or
service it.
Danger of explosion
♦
Never add flammable liquids of any kind (oil, gas, perfume) to the fog liquid.
Pay attention to all warning labels and instructions printed on the exterior of your ANTARI Fog
Machine
♦
Use only the high-quality, water-based fog liquid that your dealer recommends. Other fog
liquids may cause clogging or “spitting”.
♦
Always make sure there is sufficient liquid in the fog liquid tank. Operating this unit
without liquid will cause damage to the pump as well as over-heating of the heater.
♦
If your ANTARI Fog Machine fails to work properly, discontinue use immediately. Drain all
fog liquid from the tank, pack the unit securely (preferably in the original packing material),
and return it to your ANTARI dealer for service.
♦
Always drain tank before mailing or transporting this unit.
♦
Never drink fog liquid. If it is ingested, call a doctor immediately. If fog liquid comes in
contact with skin or eyes, rinse thoroughly with water.
Unpacking & Inspection
Open the shipping carton and verify that all equipment necessary to operate the system has
arrived intact. Refer to the “Features” section for information on what items are included with
your model. If any equipment is missing contact your ANTARI dealer immediately.
Before beginning initial setup of your ANTARI Fog Machine, make sure that there is no
evident damage caused by transportation. In the event that the unit’s housing or cable is
damaged, do not plug it in and do not attempt to use it until after contacting your ANTARI
dealer for assistance.
Setup
♦
Remove all packing materials from shipping box. Check that all
foam and plastic padding is removed, especially in the nozzle
area.
♦
Place fog machine on a flat surface and remove fog liquid tank
cap.
♦
Fill with ANTARI Fog Liquid or other high-quality water-based fog
fluid. Any other types of fluid can damage the unit. When filled,
place cap back on liquid tank.
♦
Fill the chamber with regular ice cubes or dry ice. The chamber
can hold as much as 8 kg ice cubes.
♦
When the chamber is filled, gently put the cover back. Tighten
the cover with appropriate force only.
♦
Firmly attach the included tube to the drainage outtake. Place
the end of the tube to a container.
♦
Firmly attach the remote control cable to the proper input on
the rear of the machine.
