Antari Fog Jet W-715, User Manual

Page: 7 / 12

7
set first:
Output Volume Setup - Press [Menu] button until LCD screen displays “Volume Output” and
then press
▲
or
▼
button to set the output percentage from 50-100%.
After finishing the above setting, go back to main screen by pressing [Stop] button.
To activate Volume Mode, press [Volume] button under main screen. To deactivate
Volume Mode, press [Stop] button.
Note: Under Volume Mode, fogger emits fog continuously until a re-heat is needed.
2-Second Jet Operation
To activate 2-Second Jet Mode, press [Menu] button until LCD screen displays “2-Second
Jet Output” and then press
▲
or
▼
button to activate or deactivate 2-Second Jet Mode.
Once the 2-Second Jet Mode is activated, the main screen will keep showing “2-Sec Jet
Mode. Press [Volume] button and the fog will be emitted for 2 seconds with maximum output
(100%).
DMX Operation
Making the DMX Connection – Connect machine to a DMX controller or to one of the
machines in the DMX chain. The machine uses an 3-pin and 5-pin XLR connector for DMX
connection, the connector is located on the rear of the machine.
Address Setup – Press [Menu] until LCD screen displays “DMX512 Add:” and then press
▲
or
▼
button to set the DMX address from 1-512.The machine occupies 1 control channel.
The starting address is defined as the first channel from which the machine will respond to
the controller. Always double check to make sure there are no overlapping channles in order
to control the machine correctly.