7
Maintenance
Do not allow the fog liquid to become contaminated. Always replace the caps on the fog liquid
container and the fog machine liquid tank immediately after filling.After every 40 hours of continuous
operation, it is recommended to run distilled water through the system to prevent the accumulation of
particulate matter in the heating element. When cleaning, use only a clean, lint-free cloth. An effective
cleaning regimen is as follows:
1.
While unit is unplugged and cool, unscrew nozzle at very front of unit and clean out debris with
vinegar and a pipe cleaner, making sure that the hole is free of clogs.
2.
Empty all fog fluid from machine. Add cleaning solution to tank. Plug unit in and begin warm up.
3.
Run unit in a well-ventilated area until tank is empty.
4.
Replace nozzle and refill with liquid.
Cleaning your fog machine regularly will help reduce costly parts replacement and repair charges.
Important
Always monitor tank fluid level as you are fogging. Running a fog machine with no fluid can
permanently damage the unit. If you experience low output, pump noise or no output at all, unplug
immediately. Check fluid level, the external fuse, remote connection, and power from the wall. If all of
the above appears to be O.K., plug the unit in again. If fog does not come out after pressing the
remote button for 30 seconds, check the hose attached to the tank to make sure there is fluid going
through the hose. If you are unable to determine the cause of the problem, do not simply continue
pushing the remote button, as this may damage the unit. Return the machine to your Antari dealer.
Performance Notes
All fog machines develop condensation around the output nozzle. Because this may result in
some moisture accumulation on the surface below the output nozzle, consider this
condensation when installing your unit.
Fog machines may sputter small amounts of fog occasionally during operation and for a minute
or so after being turned off.
All fog machines have a recycling period after bursts of fog when the machine will shut itself
down for a short period in order to heat back up. During this time no fog can be produced.
Only for liquids with certified suitability.
Save these instructions
