Antaira Technologies - Industrial Ethernet Switches
LNP-0800G-M12-67-24 User Manual V1.0
7
connections. Auto MDI/MDIX means that you can connect to another switch or workstation without
changing straight through or crossover cabling. See pin assignment shown in
Table 2.2
.
M12 8-Pin X-Coded Female Connector
Pinouts
10/100Base-T(X) Signal
1000Base-T Signal
1
Transmit Data + (TX+)
BI_DA+
2
Transmit Data
– (TX-)
BI_DA-
3
Transmit Data + (RX+)
BI_DB+
4
Transmit Data
– (RX-)
BI_DB-
5
BI_DD+
6
BI_DD-
7
BI_DC+
8
BI_DC-
Table 2.2
NOTE:
“+” and “
-
” signs represent the polarity of the wires that make up each wire pair.
Connection of Cables
Use the twisted-pair cable, category 5e, or the above cabling for M12 port connections. The
cable between the Ethernet switch and the link partner (switch, hub, workstation, etc.) must be
less than 100 meters (328 ft.) long.
•
Minimum Wire Gauge: 24AWG
•
Maximum Transmission Length: 100m (328ft)
Caution:
1.
Please use with copper conductors only.
2.
Use conductors with insulation rated for at least 60°C.
3.
Base the conductor Ampacity on a maximum termination temperature of 60°C.
2.7 Power Inputs
This industrial Ethernet switch provides dual DC power inputs for redundancy through an M12
4-Pin T-Coded male connector. Prepare the M12 4-Pin T-Coded cable for power connection.
Table 2.3
shows the pin assignment.
