21
3.2 Connecting EVC-3001 / EVC-3010
3.2.1 Connecting Standalone PC
Refer to the following procedures to setup the EVC-3001 to a
standalone PC.
1. Set the EVC-3001 to be CO or CPE mode from the DIP switch
at the rear panel.
2. Power on the EVC-3001 by connecting its power source.
3. Power LED will illuminate.
4. Connect VDSL line from another VDSL device to VDSL port of
the EVC-3001.
5. LNK LED will blink to illuminate.
6. Connect telephone to the PHONE port.
7. Connect Ethernet port to PC Network Interface Card (NIC) via
regular Cat. 5, 5e or 6 cable.
EVC-3001
VDSL
Phone
Phone
RJ-11 Phone Jack
RJ-45
Cat.5 Twisted Pair Cable
RJ-11 Line Cord
RJ-11 Line Cord
TP
Figure 3-3:
Connecting Standalone PC