System Overview
End-of-Line Devices
24
IQ-301 PN 50036:F 10/29/2001
1.8 End-of-Line Devices
1.8.1 Overview
Table 4 contains a list of the end-of-line devices that you can install in an
AUTOPULSE IQ-301 system:
Table 4 End-of-Line Devices
1.9 Annunciation Modules (Notifier)
1.9.1 Overview
For instructions on installing
annunciation modules, refer to
Appendix C “Annunciators” on
page 140.
This section contains brief descriptions and the model numbers of annunciator modules
that can be connected to the control panel. Communication between the control panel
and annunciators takes place over a two-wire serial interface connected to an EIA-485
connector (TB5) on the CPU. For detailed wiring requirements, refer to the appropriate
annunciator manuals.
1.9.2 Annunciator Control Module-8R (ACM-8R)
The ACM-8R provides the AUTOPULSE IQ-301 with a
mappable relay control module. ACM-8R relays can be
selected for mapping anywhere in the system memory map
(in groups of eight). Features of the ACM-8R include the
following:
•
Provides eight Form-C relays with 5 A contacts.
•
Tracks any group of eight zones within the system.
1.9.3 LDM Series Lamp Driver Modules
The LDM-32 Lamp Driver Annunciator Module provides 32
alarm lamp driver outputs for connection to a custom graphic
annunciator. You can also set the LDM-32 with a DIP switch
for 16 alarm, 16 trouble and 16 switch inputs for control of
such system functions as Signal Silence and System Reset.
•
Lamp Driver Annunciator Expander Module
(LDM-E32) – Expands the LDM-32 by 32 system
points, to a maximum of 64 points.
Option
Description
Notes
A2143-00
(System Sensor)
A 47K End-Of-Line Resistor
(ELR) Assembly ELR used in the
supervision of monitor, control
and relay module circuits.
Supplied with monitor, control
and relay modules.
A2143-10
(System Sensor)
The 3.9K End-Of-Line Resistor
(ELR) Assembly used with
two-wire detector modules.
Supplied with two-wire
detector modules.
N-ELR Resistor plate
(Notifier)
An N-ELR, required for Canadian
installations, provides connection
for a resistor to mount to an ELR
plate.
• Use 4.7K for the NAC
circuits.
• Use 47K for monitor,
control and relay modules.
Summary of Contents for AUTOPULSE IQ-301
Page 195: ...IQ 301 PN 50036 F 10 29 2001 195...
