Anslut 017392, Operating Instructions Manual

Page: 17 / 19

EN
17
SYMBOLS
Read the instructions.
Must not be covered.
Approved in accordance with
the relevant directives.
Recycle end-of-life product
in accordance with local
regulations.
TECHNICAL DATA
Rated voltage 230 V ~ 50 Hz
Output 400 W
Protection rating IP20
Temperature interval 15–35°C
Size 165 x 320 x 165 mm
Weight 1.1 kg
DESCRIPTION
CONTROL PANEL
1. Set temperature
2. Button for flame effect on/off
3. Button to increase temperature/run time
4. Button to reduce temperature/run time
5. Button to set temperature/run time
FIG. 1
REMOTE CONTROL
1. Button on/off (standby mode)
2. Button for flame effect on/off
3. Button to increase temperature/run time
4. Button to reduce temperature/run time
5. Button to set temperature/run time
FIG. 2
USE
The product can be operated with the control
panel or with the supplied remote control.
1. Place the product on a level, stable,
dry and heat resistant surface with free
space above and out of the reach of
children and pets.
2. Plug the plug into an easily accessible and
correctly installed power point.
3. Set the power switch on the back of
the product to the ON position.
The display first shows a numerical value
for temperature and then OFF (for off
mode). The fan also starts and runs for
about 10 to 20 seconds. The product then
goes into standby mode.
4. To activate heating mode, press the
button (3) on the remote control or one
of the buttons on the product. The display
shows the last temperature setting.
5. Press the button (2) to activate the flame
effect. Switch off by pressing the button
again.
6. Press the button (5) to change the
temperature setting. The numerical value
on the display flashes.
7. Set the required temperature (15 to 35°C)
with the + and – buttons. The numerical
value on the display stops flashing when
the set temperature is reached.
When the product is switched on,
heating mode switches off automatically
when the set point temperature is
reached and starts again when the
temperature drops.
8. Switch off the product by putting the
power switch in the OFF position.
The product can be put in standby mode
with the button (1) on the remote control.
It takes about 15 seconds before the fan
stops after pressing the button. To start
the product again, press the button on
the remote control or one of the buttons