Anslut 006859, Original Instructions Manual

Page: 31 / 64

31
2022_001
7
Put the product on the 2 top brackets. Make sure that
the top brackets are fully in the 2 slots (E) on the rear
side of the product.
8
Make sure that the shorter part on the 2 bottom
brackets is flat against the wall and mark the position
for the bottom bracket holes.
9
Remove the product from the wall.
10
Drill 2 holes for applicable screw plugs at the
markings holes and install applicable screw plugs in
the holes.
11
Put the product on the 2 top brackets again. Make
sure that the top brackets are fully in the 2 slots on
the rear side of the product. (Figure 8)
12
Install the 2 bottom brackets with screws in the screw
plugs on the wall.
4 Operation
4.1 To do before you use the product
for the first time
1
Make sure that the product is installed correctly.
Refer to “3.1 To install the product” on page 30.
2
Make sure that the power switch is in the off position
(0).
3
Connect the power plug to a power outlet.
Warning! Only connect the product to a power outlet
that is correctly earthed. Speak to an authorized electrician
if you are not sure.
Warning! Only connect the product to a power outlet
that has a maximum tripping current of 30 mA. Speak to an
authorized electrician if you are not sure.
4.2 To start the product
Warning! Do not touch hot surfaces. Some surfaces
on the product become hot when the product is in opera-
tion.
1
Put the power switch in the on position (I).
2
Press the ON/OFF button on the control panel. The
LED display comes on.
Note! The display goes off automatically after 2 minutes and
“ON” shows on the display. Press any button to make the
display come on again.
4.3 To stop the product
Warning!
Do not touch hot surfaces. Some surfaces
on the product become hot when the product is in opera-
tion.
1
Press the ON/OFF button on the control panel. “OFF”
shows on the display.
2
Put the power switch in the off position (0).
Note! Sounds can be heard from the product after
operation. This is normal when the material in the product
becomes cool.
4.4 To adjust the date and time
Note! It is only necessary to adjust the date and time if
you use the timer functions. If you do not use the timer
functions, adjust the day of the week to “1” and adjust the
time to “00:00”.
1
Start the product. Refer to “4.2 To start the product”
on page 31.
2
Press the SET button until “SET” shows in the display.
The numbers for the days of the week flash in the
bottom of the display.
3
Press the + and - buttons until the number for the
required day of the week show in the bottom of the
display.
4
Press the SET button. The numbers for the hours
flash.
5
Press the + and - buttons until the required hours
show in the display.
6
Press the SET button. The numbers for the minutes
flash.
7
Press the + and - buttons until the required minutes
show in the display. Press the SET button.
Note! The time and date will be reset if the power switch is
put in the off position (0) or if the power plug is disconnect-
ed.