EN
11
is firmly fixed in the ground. If it is difficult
to put the ground spike in the ground,
make a hole with a poker. The ground spike
must not be pressed down further than to
the recess for the lamp cord.
4. Connect the lamp to the connection cord
by putting the lamp connector in the outlet
on the connection cord and tightening the
threaded locking sleeve.
5. Connect the connection cord to the
transformer by putting the connection cord
connector in the outlet and tightening the
threaded locking sleeve.
6. Plug the transformer into the power point.
FIG. 3
MAINTENANCE
Replacing light source
1.
Disconnect the transformer from the
mains.
2.
Release the diffusor from the socket by
turning it anticlockwise.
3.
Lift off the diffusor.
4.
Remove the old light source.
5.
Insert a new light source of the same
type.
6.
Put the diffusor on the socket and turn it
clockwise to fasten it.
7.
Connect the transformer to the mains.
Troubleshooting
If one or more lamps do not light up, check:
– That the mains connection is working.
– That the lamps are correctly connected
to the connection cord.
– That the light sources are intact.
Summary of Contents for 001947
Page 3: ...1 3 2...
