Anritsu 3GPP, Measurement Manual

Page: 184 / 244

6-11 Setup Menu TD-LTE Signal Analyzer
6-32 PN: 10580-00234 Rev. Y 3GPP MG
6-11 Setup Menu
Key Sequence:
Setup
BW: Opens the selectable bandwidth list.
Cyclic Prefix: Press this submenu key to set the instrument to measure
signal with a Normal or Extended Cyclic Prefix, or to allow the instrument
to detect the Cyclic Prefix automatically.
EVM Max Hold: Turn the EVM Max Hold submenu key On to display both
the Maximum EVM value since Reset and the current measured value.
This applies to EVM RMS and Peak values. Selecting Off displays only
the current measured value.
EVM Mode: Press this key to select either Auto or PBCH Only. Selecting
Auto measures PDSCH if data is available, otherwise, it measures PBCH.
Selecting PBCH Only forces a PBCH measurement and the constellation
measurement will only show QPSK. The instrument will automatically
choose PBCH Only mode when the OTA Scanner is used.
Sync: Press this key to open the “Sync Menu” on page 6-33 .
Freq Err Avg Cnt: When the count is greater than one, the frequency
error value is averaged over past measurements. If the count is one, then
no averaging occurs.
U/D Link Config: Press this key to set the Uplink/Downlink configuration,
also known as the Frame Format. Use the keypad, arrow keys, or the
rotary knob to set the value between 0 and 6 inclusive. This selection
determines which subframes are uplink subframes and which are
downlink subframes, and where the transitions between uplink and
downlink subframes occur.
Trigger: Press this key to open the “Trigger Menu” on page 6-33 .
Figure 6-25. TD-LTE Setup Menu
Setup
BW
10 MHz
EVM Mode
Auto PBCH Only
Freq Err Avg Cnt
1
EVM Max Hold
Off On
Cyclic Prefix
Auto Norm Extd
U/D Link Config
0
Trigger
Sync