20
- -
A moment of distraction while operating this machine can cause serious personal injury.
Avoid accidental starting of the machine. Make sure the switch is in the "open" position before
connecting to the network, picking up or transporting this machine. Transport electrical
machines with your finger on the switch or plug Electrical machines that have a switch in the
"OFF" position can put your safety at risk and cause accidents.
Remove all keys or hand tools from the machine and from the work area before starting this
machine. A key or tool left near the machine can be touched by a part of the moving machine
and be projected causing personal injury.
Do not overdo it. Keep your feet firmly on the ground and keep balance throughout moment.
Always use safety equipment. Wear waterproof clothing, boots, gloves and goggles that protect
from splashing water and dirt.
Store inactive power tools out of the reach of children.
2.3. SAFETY WORK AREA
Ensure that all current carrying elements (plugs, switches, light bulbs,
etc.) are protected against jets of water in the work area. Unprotected conductive elements can
short-circuit the system or cause a cramp to the user.
Keep the work area clean and work in good lighting. The disordered areas and
Darkness causes accidents.
Do not operate this machine in explosive atmospheres as well as in the presence of flammable
liquids, gases and dust. Electric machines create sparks that can ignite dust or fumes.
Keep children and curious people away while operating this machine. Distractions can cause
you to lose control. Keep children, people or animals from entering your work area.
Do not use this device when there are other people in the work area who are not protected by
protective clothing, boots and goggles.
2.4. BASIC SECURITY
The user must use D226ML-5 knowing the security measures according to the regulations in
force.
In particular, you must:
ALWAYS use protective glasses
NEVER use D226ML-5 near electric cables
NEVER use D226ML-5 in case of rain or storm, anyway work in a dry environment
Before any cleaning and/or maintenance action disconnect the electric cables
After using the shaker, disconnect the electric cables and store D226ML-5 in a dry and
cool place
3. INSTALLATION: HOW TO START
Put inside the head the adapter for the transmission shaft of your machine
Measure the pole diameter and put the proper bushing inside the head in the right
position
Put the head on the pole and mark with a felt pen the position of the lateral hole
Take the head off the pole and drill the pole with a 5.3mm drill tip
Put again the head on the pole and tighten the screw on the right side (anti-rotation
screw) and then the 4 screws to fasten the pole (not too much)
Plug the carbon rods into the shock absorbers of the combs and fasten them with the
nuts
The head is ready for use
