Anolis ArcPad Zoom 48MC, User Manual

Page: 14 / 22

ArcPad Zoom 48MC
14
In order to reset this counter, press and hold both [UP] and [DOWN] buttons and the
[Enter] button at the same time.
Sw Ver - Software versions . Select this item to read version of software in fixture processors (IC-1, IC-2, IC-3, WL).
6.3 Personality (Pers)
DMX Pres - DMX preset . Use the menu to select desired channel mode.
Mode 1 - 16 control channels
Mode 2 - 10 control channels
RGB Cnt --- RGB counting . If this function is active, the white channel (channel 4) uses red, green and blue chanels
in proportional relation to ensure max. light output in a white colour ( if white channel =full, also red, green and
blue channels are full).
DMX In
-
DMX input
.
Use the menu to select mode of receiving DMX signal.
Wired
-
DMX signal is received by means of the standard DMX cable.
Wireless - DMX signal is received by means of the inbuilt wireless module (if the module is installed).
Display - Display adjusting . This menu allows you to adjust the display behaviour.
Turn - This function rotates menu 180 degrees from current orientation.
On/Off T - This function allows you to keep the display permanent on or turn it off two
minutes after last pressing any button on the control panel.
Contrast - Use this function to adjust contrast of the display (0-100%).
Backlight - Use this function to adjust backlight of the display (0-100%).
C Cal M
-
Colour calibration mode
. If the functin is on, the white output (2700K-8000K) from the fixture (and also
mixed colours) is more uniform.
C Mix M - Colour mixing mode . This item allows switching into RGBW or CMY mode. In the CMY mode, the
white(8bit) and white (16) bit channels are not active.
Dimer C – Dimmer curve . This menu item allows to set linear (Linear) or square law (SqL) dimmer curve.
Temp Uni - Temperature unit . Use the menu item to change temperature unit from °C to °F.
I Ef Pos - Init effect positions . Use the menu to set all effects to the desired positions at which they will stay after
switching the fixture on without DMX signal connected.
Defaults - The menu item allows to set all fixture parameters to the default (factory) values.
6.4 Manual Control (Manual)
Use the menu to control all fixture channels by means of the control panel. Displayed menu items depend on
selected DMX mode.
6.5 Test program (Test Prg)
Use this menu item to run a special demo-test sequences without an external controller, which will show you some
possibilities of using ArcPad Zoom 48MC.