Annovi Reverberi 1380, Translation Of The Original Instructions

Page: 10 / 84

10 English
3.1.20
W
arning
.
DO NOT move the machine by pulling on the high pressure hose.
3.1.21
W
arning
.
When directed towards tyres, tyre valves or other pressurised
components, the high pressure jet is potentially dangerous. Do not use the rotary
nozzle kit, and always keep the jet at a distance of at least 30 cm during cleaning.
3.1.22
W
arning
.
The use of non-original accessories and any other accessories not
specifically intended for the model in question is prohibited. All modifications
to the machine are prohibited; any modifications shall render the Declaration of
Conformity null and void and relieve the manufacturer of all liability under civil
and criminal law.
3.1.23
W
arning
.
DO NOT use unsuitable diesels as this may be hazardous or damage
the machine.
3.1.24
W
arning
.
DO NOT touch the boiler or the exhausts during operation. Burning
hazard.
3.2 SAFETY “MUSTS”
3.2.1
W
arning
.
All electrical conductors MUST BE PROTECTED against the water jet.
3.2.2
W
arning
.
The electric supply connection must be made by a qualified electrician
and comply with IEC 60364-1. Either a residual current device that will cut off the
power supply to the machine if the leakage current to earth exceeds 30 mA for
30 ms or a ground fault interrupt device must be installed.
3.2.3
W
arning
.
DURING start-up, the machine may cause network noise.
3.2.4
W
arning
.
Use of a residual current device will provide additional protection for
the operator (30 mA).
3.2.5
W
arning
.
Models supplied without plug must be installed by qualified staff.
3.2.6
W
arning
.
Use only approved electrical extension leads with suitable conductor
cross-section.
3.2.7
W
arning
.
Always turn off the switch when leaving the machine unattended.
3.2.8
W
arning
.
High pressure may cause parts to rebound: wear all the protective
clothing (PPE) and equipment needed to ensure the operator’s safety.
3.2.9
W
arning
.
Before doing work on the machine, REMOVE the plug.
3.2.10
W
arning
.
Before pressing the trigger, GRIP the trigger gun firmly to counteract
the recoil.