Page
9
of
16
8 Operation
Note
: Ensure the Micro Fibre Pad is fitted before use. To prevent damage
to the floor never use the steam mop without the micro fibre pad.
•
After fitting the Micro Fibre Pad, stand the steam mop upright.
•
Open the water tank cap by pulling up on the tab.
•
Fill the water tank to the “Max” mark (on the window) then refit the cap
securely.
•
Ensuring the power cord is fully unwound, insert the plug into the power
point and switch on. The Indicator light on the front face of the Steam
Cleaner Body will illuminate and Flash.
•
Allow 15 – 30 seconds (depending on the initial water temperature) for the
element to heat up.
NOTE: Read the section on “Recommended Floor Surfaces” prior to
use.
•
Whilst in the upright “Park” position, the steam will not be generated.
To start the steam, pull the handle backward, ensuring the floor head
remains flat on the floor, and then start to push and pull the Steam Mop
over the floor as if you are vacuuming the floor.
Note: Tilting the handle back activates the water pump which in turn creates
the steam generation.
Note:
A small amount of water may initially be ejected from the base when
heating starts. This is normal.
Summary of Contents for JC-230
Page 1: ...Steam Mop User Manual Model No JC 230 Rev 1 READ AND SAVE THESE INSTRUCTIONS...
Page 2: ...Page 2 of 16...
Page 14: ...Page 14 of 16...
Page 16: ...Page 16 of 16...
