Page
13
of
16
10.1 Cleaning the Steam Mop
Do not clean the Steam Mop or components with petrol or any other
flammable liquids, solvents, etc.
Use only a moist cloth and mild detergent for cleaning the Steam Mop.
Clean only the outside of the Steam Mop.
After cleaning, wipe off the moisture with a dry cloth.
Do Not
place in water to clean.
11 Troubleshooting
No Steam.
Power Not Switched On.
Water has not heated up
Handle has not been tilted
back far enough.
No water in the tank.
Blocked Steam Hole
Switch On at power point.
Allow approximately 20 – 30
seconds for the water to heat.
Tilt handle back ensuring the floor
head is still flat on the floor.
Add water to the water tank.
Clean the steam hole as described
under “User Maintenance”
A small amount of
water is ejected
instead of steam
This is normal when the
element is heating up.
This is normal
Indicator Light will
not come on.
Power Not Switched On.
Switch On at power point.
Indicator Light
flashing.
Water is heating.
Allow water to heat for
approximately 20 – 30 sends
before use.
Summary of Contents for JC-230
Page 1: ...Steam Mop User Manual Model No JC 230 Rev 1 READ AND SAVE THESE INSTRUCTIONS...
Page 2: ...Page 2 of 16...
Page 14: ...Page 14 of 16...
Page 16: ...Page 16 of 16...
