Page 8 of 12
3.3 Safety Grille and Fan Blade
To assemble the safety grille and blade assembly, first remove the 4 screws from the
motor assembly and as identified.
Fit the rear safety grille into position (with the handle on the back of the grille at the top)
and refit the 4 screws and tighten.
Remove the protective plastic sleeve from the motor spindle shaft and discard.
Next, rotate the motor spindle until the area with the “flat” surface is facing up.
Slide the fan blade onto the spindle ensuring the screw is lined up with the “flat” surface
on the spindle as shown.
Push on until the end of the spindle is flush with the end of the fan blade hole, then
tighten the screw.
“Flat” surface on
Motor Spindle
Fan Blade Screw
Fan Blade hole flush
with Motor Spindle
