Copyright © 2019 ANK Audio Kits
www.AudioNoteKits.com
[email protected]
Page 46
Let’s start with the White/White-Grey pair:
Have a look at the step below, then consider this tip.
You may want to trim the tinned wire to the
desired length and then place the crimp over the tinned bare wire. If it doesn't fit try smoothing out
the tinned wire with soldering iron then add some solder in the hole showing: use a fine-tipped
soldering iron and make sure the solder “takes” such that the solder is shiny and the wire has
accepted the solder.
Cut these wires
5
, strip the ends off, twist the two ends together, tin them, add a crimp to the end,
solder the wires onto the crimp, and then install the heatshrink (
)
Similarly, prepare the Black/Black-Grey pair.
Push the crimped White/White-Grey and Black/Black-Grey Mains Primary wires that you've just
prepared onto the wider spread lugs of the Rocker Switch, as shown in the graphic above.
Take the prepared Red/Black twisted cable and complete the connections as shown in the
graphic.
5
Leave about 5 inches of twisted White/White-Grey wire, at least.
