Copyright © 2019 ANK Audio Kits
www.AudioNoteKits.com
[email protected]
Page 54
Referencing the graphic on the previous page:
Connect a Black wire from the NEGATIVE terminal of the 30uf 600V capacitor (with the
Brown/White wire already positioned there) to the NEGATIVE terminal of the input (IN) section of
the 220uf 450V capacitor (that you already connected a Choke wire to the POSITIVE terminal of).
Solder both connections.
Connect and solder a Red wire from the POSITIVE terminal of the 30uf 600V capacitor (with one of
the Choke wires already positioned there) to the right end of the 40R (40 ohm) Gold Mills chassis
mounted resistor.
Connect and solder 2 Black wires to the NEGATIVE terminal of the 100uf + 100uf capacitors, as
shown above.
Connect and solder the other end of one of these Black wires on the unused right side of the 47K
resistor in the ceramic posts. Add and solder 2 short jumpers as shown above, connecting that
post to the 2 posts above it.
Position the other end of the other Black wire onto the NEGATIVE terminal of the output (OUT)
section of the 220uf 450V capacitor with one end of another Black wire, and solder the two of
them together to the capacitor, as shown above.
Connect and solder the other end of the Black wire added in the previous step to unused right side
of the 100R in the ceramic posts.
Connect and solder one end of a Red wire from the upper POSITIVE terminal of the 100uf + 100uf
capacitors to the left end of the 15K resistor in the second position of the ceramic posts. Solder
the connection.
Connect and solder one end of a Red wire from the lower POSITIVE terminal of the 100uf + 100uf
capacitors to the right end of the top 15K resistor. Solder the connection.
Connect and solder a Red wire to the right end of the 15K resistor in the second position in the
ceramic posts.
Connect and solder the other end of the Red wire in the previous step and one end of another Red
wire to the right end of the 330K resistor in the ceramic posts.
Take the Black wire coming from the Output transformer grommet and connect it with the other
end of the Red wire added in the previous step to the POSITIVE terminal of the output (OUT)
section of the 220uf 450V capacitor. Solder the connections. (The Red wire coming from the
Output transformer grommet will be connected later.)
Before you go any farther, we strongly recommend that you go back to the
beginning of the Power Supply section, and check every connection carefully!
