Anita Garudan GPS/G-3525 Series, User'S Manual And Spare Parts Book

Page: 11 / 87

ANITA ©
MP00800EN_161116 11
7. BOBBIN WINDING
A) Insert the bobbin ( 3) on bobbin winder
shaft (1 ) .
B) Press the winder lever ( 2) to activate the
operation and start the machine.
C) When the bobbin is fully wound with
thread, the winder lever releases the
bobbin. Cut the thread by knife (4), see fig.
13
Fig . 1 3
8. ADJUSTING HEIGHT OF PRESSER FOOT
A. Loosen screw of the presser foot (1 ) in
the lower end position and set the height of
the foot so the foot tip is approximately
0.5mm above the surface of the sewn
material, then tighten screw, fig . 14
Fig . 14
9. USED OIL DISPOSAL
The oil container (1 ) attached under the
base table should be taken away for
cleanup after it is full with oil.
Fig . 1 5
www.garudan.cz