Animo WKT 5n HA User Manual Download Page 6

3.  INsTaLLaTIoN 

Follow the instructions to place and connect the machine, specified below.

3.1  positioning the appliance 

 

Place the unit:

• 

At counter level and on a solid flat surface.

• 

Where it can be connected to the electricity grid.

• 

In a way that it is not causing any damage in case of leakage.

 

3.2  Connection to the water supply system (model va)

• 

The WKT 5nhh VA requires a water stop valve near the machine.

• 

Connect the provided water hose between the cold water supply and the water connection on  

 

the back of the unit. The hose has a length of 1.5 m.

 

3.3  Connection to the electricity supply system

 

Depending on the model, the appliance should be connected according to the instructions 

 

in (fig. 2).

• 

For 240V 1 phase with plug socket.

• 

For 240V 1 phase (3-core cable).

 

The following remarks apply to fig. 2:

• 

If  the  plug  fitted  on  the  electric  cable  does  not  fit  in  your  socket,  you  have  to  replace  it

 

 

with a suitable one. 

• 

The replaced plug should be thrown away as it can be dangerous if plugged in a socket.

 

The following points should be observed when wiring a new plug:

1. 

The green/yellow-colored wire (“EARTH”) should be connected to the terminal which is

 

 

either marked with the letter “E”, the “earth” symbol (    ), colored green or green/yellow.

2. 

The blue-colored wire (“NEUTRAL”) should be connected to the terminal which is either

 

 

marked with the letter “N” or colored black.

3. 

The brown-colored wire (“PHASE”) should be connected to the terminal which is either

 

 

marked with the letter “L” or colored red.

 

WaRNING 

 

-  Always  remove  the  plug  from  the  socket  if  the  machine  has  to  be  opened  for  repair  or 

 

maintenance.

-  Do  not  position  the  machine  in  areas  where  the  temperature  drops  below  freezing  point 

 

because there is always water left in the system.

-  Always plug the machine into an earthed wall socket.

-  Do not submerge or spray the machine.

-  Have all repairs carried out by a specially trained technician.

-  During use, some parts will become very hot.

-  In case the machine is not used for a relatively long period of time, it is advisable to remove 

 

the plug from the socket and to close the water drain* (*model VA).

2015/02 Rev. 1.0

M-LINE

15

GB

Summary of Contents for WKT 5n HA













Reviews: