- 12 -
3378750_GB_inst
ENGLISH
GB
CONVERSION OF GAS SUPPLY
The manufacturer has tested the appliance with its
own mains gas, identifi ed by the sticker applied to
the nameplate.
If the type of gas to be connected is diff erent from
that used for testing, proceed as follows.
1)
Turn off the gas supply tap
(A)
.
2)
Change the burner nozzle (see pag. 15).
3)
Remove the testing gas sticker from the dataplate
(B)
and apply the new one to identify the gas being
used.
4)
Remove the sticker from the appliance and apply
the new one
(C)
with the category of the country
of installation.
5)
Activate the “Gas type conversion” procedure.
6)
Carry out the appliance testing procedure (see
page 11)
Important
On completion of the operation, make sure that
there are no gas leaks or malfunctions.
G20
TYPE
CE n.
~
~
~
01
0051
rif.
G25
G30
G31
kW
m3/h
m3/h
Kg/h
mbar
mbar
mbar
mbar
Kg/h
kW
kW
kW
G20
TYPE
CE n.
~
~
~
01
0051
rif.
G25
G30
G31
kW
m3/h
m3/h
Kg/h
mbar
mbar
mbar
mbar
Kg/h
kW
kW
kW
AT: II2H3P
IS-MT: I3B/P
IT-AL-BG-CH-CZ-ES-GB-GR-HR-IE-MK-PT-RO: II2H3P - PL: II2E3P
NL: II2L3P
LU: I2H
LU: I3
G30/G31 28-30/37
G20 20mbar
(2H) (2E)
BE: II2E(S)B3P - FR: II2Esi3P
FR:
G31 37mbar (3P)
HU: II2HS3B/P
G30/G31 28-30/37
AT-CH: II2H3B/P DE:II2E3B/P
NL-RO: II2L3B/P
A
C
B
TESTING OF THE APPLIANCE
Important
Before it is put into service, the system must be tested to check the operating conditions of
every single component and identify any malfunctions.
In this stage, it is important to check that all health and safety requirements have been
complied with in full.
1)
Turn on the gas and water supply taps and check that the connections are tight.
2)
Turn on the master switch to check the electrical connection.
3)
Check that the mains gas is the same as that used for commissioning of the appliance, and
carry out the conversion procedure if necessary (see page 12).
4)
Check that the gas pressure conforms to the values stated in the table at the back of the man-
ual.
5)
Check that the combustion exhaust gases comply with the requirements (see page 13).
6)
Check the water pressure and adjust if necessary (see page 13)
7)
Check that the safety device is operating correctly.
8)
Carry out a cooking cycle without food to ensure that the appliance is operating correctly.
After testing, if necessary instruct the user in all the skills necessary for putting the appliance into
operation in conditions of safety, in accordance with legal requirements.
Important
During performance of the test procedure and on completion of the operation, make sure
that there are no gas leaks or malfunctions.
