- 18 -
C1
39
60
36
00
_1
.fm
IT
AUS
DE
FR
ES
To carry out this operation,
proceed as follows.
1- Turn off the gas supply
tap.
2 - Pull off the knob (
A
).
3 - Undo the screws (
B
) and
remove the control panel
(
C
).
4 - Undo the screws (
D
) and
extract the cap (
E
).
5 - Pull off the cone (
F
).
6 - Clean the cone (
F
) and its
seat.
7 - Coat the cone with grease
(
F
), fit it in its seat and turn it a few times.
8 - Pull off the cone (
F
) to remove the excess grease.
9 - Replace the cone (
F
), the cap (
E
), the control pan-
el (
C
) and the knob (
A
).
Before carrying out any replacement procedure, acti-
vate all the safety devices provided and decide
whether staff at work and those in the vicinity should
be informed. In particular, turn off the gas supply tap
and prevent access to all devices which might cause
unexpected health and safety hazards if turned on.
If work parts have to be replaced, use original spare
parts only.
The manufacturer declines all responsibly for injury or
damage to components due to the use of non original
parts, or extraordinary work on the appliance which
may modify the safety requirements without the man-
ufacturer's authorisation.
When ordering components, follow the instructions
provided in the parts catalogue.
To carry out this operation,
proceed as follows.
1- Turn off the gas supply
tap.
2 - Pull off the knob (
A
).
3 - Undo the screws (
B
) and
remove the control panel
(
C
).
4 - Unscrew the nozzle (
D
)
and replace it with the one
suitable for the type of gas
in use (see table at back of
manual).
5 - Replace the control panel
(
C
) and the knob (
A
).
GREASING THE GAS TAP
REPLACING PARTS
9
RECOMMENDATIONS FOR REPLACING PARTS
REPLACING THE PLATE BURNER NOZZLE
C
A
B
F
D
IDM-39603618200.tif
E
A
C
B
D
IDM-39603618300.tif