OFF
T
1
GB
5 cm
L
1
L
2
L
3
D
9
2
1
N
L
3
N
- 1 -
2
1
• Refer to the general warnings in
Chapter 5, Section 1 of the
manual A
;
• To access the terminal block, open the control panel as described
in following
point 1.3
;
• Feed the cable from the main switch through the cable gland and
connect to the terminal block as shown in the wiring diagram.
• The wall-mounted main switch must be 3-pole with adjustable
RCCB and adjustable sensitivity
I
∆
n
.
The power supply cable must be resistant to oil and must have
characteristics at least type
H05 RN-F
(245 IEC 57) and insulation
able to withstand a temperature of at least 90 °C.
The wires must be fixed with the cable gland and protected as far as
the wiring terminal blocks with the fibreglass braid supplied.
Equipotential connection
• The equipotential bonding terminal (
»
) is located in the vicinity of
the terminal block.
Operating voltage
• The appliance is supplied set to operate at 400 V TPN (see wiring dia-
gram in appendix); if required it can be converted at 230 V TP as
shown in the diagram on the left :
fit bridge
D
(supplied) on to the power supply terminal block
move the connection strips on the heating element terminal block.
The appliance can be installed directly against a wall provided that the
wall materials or wall finish (panelling, etc.) can withstand temperatures
of up to 150 °C, otherwise leave a minimum clearance of
5 cm
.
1. Installation
Install the appliance under an extractor hood or other extraction
system to remove vapours and fumes emitted during use.
Install a thermal-magnetic switch with RCCB (not supplied) on
the wall.
Appliance installed on optional base unit
: tighten the feet
fully down under the base; level by means of the lower section
of the feet.
Stand-alone installation (not side-by-side con-
figurations)
: replace the feet (supplied with the
base unit) with the flanged feet supplied on request
(use the flange as a template when drilling the
floor). After levelling, secure the feed by means of
expansion plugs.
1.1 Positioning the appliance
1.2 Electrical connection
