Angelcare AC300, Owner'S Manual

Page: 57 / 60

TROUBLESHOOTING
FALSE ALARMS
• Turn OFF the Nursery Unit.
• Verify the connection between the Sensor Pad and the Nursery Unit.
Unplug and reconnect the cord.
• Make sure there is no bedding between the mattress and the Sensor Pad.
• If the crib has a spring or slat base, place a hardboard between the crib base and the
Sensor Pad measuring at least 33 x 33 cm and 6 mm thick.
• Make sure Sensor Pad is positioned as described under the setup requirements.
Sensitivity may need to be adjusted, refer to Step 3.1 .
ALARM WILL NOT SOUND
• Avoid contact with the crib when the monitor is
ON
.
• Place crib near a solid supporting wall to avoid Sensor Pad from detecting movement
from outside the crib.
• Turn OFF crib mobile, fans, loud music or anything else that may cause vibration.
• You may need to decrease the sensitivity, refer to Step 3.1 .
ALARM INDICATOR LIGHT IS FLASHING RED
(MONITOR IS BARELY DETECTING MOVEMENT)
• Make sure there is no bedding between the mattress and the Sensor Pad.
• The Sensor Pad must rest on a completely flat and firm surface. If the crib has a spring
or slat base, place a hard board between the crib base and the Sensor Pad measuring at
least 33 x 33 cm and 6 mm thick.
• Make sure Sensor Pad is positioned as described under the setup requirements.
Sensitivity may need to be adjusted, refer to
Step 3.1
.
NO POWER
• Check or replace batteries.
• Make sure Monitor is
ON .
If you experience a problem that is not noted in this manual,
please do not return the product to the store. If you are not completely
satisfied or have any questions:
Belgium, The Netherlands, Luxemburg:
Please contact us at: info@mykko.be.
Other countries: Please contact your local distributor.
We may have a simple solution to your problem.
57
E
N
04mf8_Manuel_AC300_BELGIQUE_12010.indd 57 2015-10-05 4:25 PM