STEP 2 - SETTING UP THE NURSERY UNIT
1
2
1)
Remove the battery door and insert
4 AAA Alkaline Batteries (not included).
2)
Place the Nursery Unit at a
minimum
of 3 feet (0.9 m)
away from the crib.
3)
Connect the AC Adapter to the Nursery
Unit and into an electrical outlet.
NOTE:
The batteries maintain power
supply in case of power outage.
NURSERY UNIT:
Front Side
Back Side
A
F
G
H
J
A)
Channel selector ON/OFF
night light button
B) Power ON/OFF
C)
Low Battery / Power
Indicator
D)
In range ON/OFF
E)
Microphone
F)
Night Light
G)
Ventilation
H)
AC Adapter Outlet
I)
Microphone Sensitivity Dial
J)
Battery Door (not shown)
3 ft.
(0.9 m)
3
B
D
C
E
I
STEP 3 - TURNING ON YOUR MONITOR
1)
Press the Parent Unit
ON/OFF
button
for 2 seconds.
2)
Slide
ON
the Nursery Unit Power
ON/OFF
button.
NOTE:
The screen of the Parent Unit will show the
channel of transmission (C1 to C8) and after
5 seconds the room temperature and
function icons.
CHANNEL SELECTION
1
2
When the Parent Unit is turned
ON
and the Nursery Unit is
OFF
OR
If there is a lost connection
between the 2 units (refer to
troubleshooting):
The
Out-of-Range
icon will blink
on the screen and the Parent Unit
will beep.
1)
Press the “CH” key to enter or exit
the
Channel Selection
mode. The “--”
symbol will appear along with the In
Range icon which will flash.
2)
Press the channel selector on the
Nursery Unit until the
Night Light
halo
flashes.
3)
Select the channel by gently pushing
the channel selector on the Nursery
Unit (you will see the channel changing
on the Parent Unit).
4)
Once the channel is selected, press and
hold the
Channel Selector
button on
the Nursery Unit to confirm selection
(halo will stop flashing to confirm
selection).
NOTE :
Both units are always on the same channel.
If the transmission is not clear, or if you hear
interference sounds, you should change the
channel. If the interference persists, consult
the Troubleshooting section.
1
3
4
TO SELECT THE CHANNEL:
2
11
E
N
10
