AneX L/type Maintenance Manual Download Page 9

Page: 9 / 200

sides of the seat in sequence (Fig. 35). If you
want to remove the bumper, press the buttons,
and pull the handle slightly upwards (Fig. 36).
You may also remove only one side of the
bumper and leave the other side.

Safety belts

The seat of the stroller unit is equipped with
5-point safety belts. To secure the child, slide
the seatbelt locks in and tighten the seatbelts
(Fig. 37). The length of the seatbelts can also be
adjusted. If you want to make them shorter, pull
on the end of the seatbelts (Fig. 38). If you want
to extend the seatbelt, turn the plastic regulator
up and pull the lower belt. When the seatbelts
need to be unfastened, press the button, and
remove the locks from the clamp. If you wish
to change the position of the upper seatbelts,
remove the fabric from the top of the backrest,
then remove the seatbelts and change their
position (Fig. 39). Put the fabric part back in
its normal position.

Child car seat

The child car seat can be mounted on the
frame of this stroller. It must be attached
to the special adapters. To secure the child’s
car seat, insert the adapters into the adapter
compartment of the frame (Fig. 40) and then
secure it (Fig. 41). To remove the adapters
from the frame, press the adapter buttons
(Fig. 42). To remove the child’s car seat from
the adapters, press the buttons under the fab-
ric on both sides of the seat at the same time.
Both the adapters and the child car seat are
locked automatically. The transport handle can
also be adjusted by pressing the red buttons
on both sides of the seat simultaneously and
adjusting it to the desired position. The car

seat can be fixed of the car (vehicle) with the
standard car seat belts as well as with the ISO-
FIX locking system. Read the manual carefully
before using the car seat.

Installing additional

accessories on the frame

There are special fasteners on both sides of the
frame for the Anex TM cup holder. The stroller is
also equipped with a shopping basket, mounted
to the frame bottom with clips (Fig. 43), buttons
on both sides of the frame (Fig. 44) and below
(Fig. 45).

Maintenance and cleaning

Please ensure that the stroller is kept clean
and dry (both the coating and the frame).
In case the stroller gets dirty or wet, it should
be dried, and the metallic parts be cleaned with
a dry cloth. Avoid getting dirt (sand, dust, etc.)
on the stroller. Please note that if you do not
do so, the product can stop functioning either
partially or fully.

The cleaning of the stroller’s coating can
be done with a wet washcloth or brush and
detergent. There is no need to take the coating
off. The color of materials and textile can fade
when exposed to sunlight for a long time. The
wear level of wheels should be controlled; the
wheels should be cleaned from dirt, it should
be dried, while its metal parts should be wiped
with a dry cloth. Periodically, remove the wheels
from the chassis and brush off any dirt or sand
on the axle of the wheel. Do not submerge the