AneX L/type, Maintenance Manual

Page: 7 / 200

7
PRE-USE PROCEDURES
Stroller assembling/disassembling
Get the stroller frame out of the box and place
it horizontally on the floor (Fig. 1). Release the
safety catch for accidental unfolding (Fig. 2),
and while holding the handle, pull up actively
to ensure that the system is locked correctly
(you should hear a characteristic sound) (Fig. 3).
To fold the frame, press both buttons and the
levers on both sides of the frame at the same
time (Fig. 4), then lower the frame handle down
to its original position. By repeating the same
steps, the frame can be folded together with
the seat without removing the stroller block for
storage or transportation. Pull the lever located
at the back of the stroller block upwards and
lower the backrest forward (Fig. 5). Finally, pull
the seat together with the footrest to the other
side and fold the frame (Fig. 6). This is possible
if the seat of the stroller block is placed in the
direction of movement as well as the child’s
face to the mother, and if there is no bumper of
the stroller block installed. The seat unit in the
direction of movement can only be folded with
a barrier.
Handle height adjustment
Push the button in the middle of the frame
handle and set the desired height (Fig. 7).
Installation and removal
of rear wheels
To mount a wheel, press the button in the
center and insert the axle into the mounting
position (until you hear a specific sound)
(Fig. 8). To remove the wheel, push and hold
the button in the middle and pull the wheel
parallel to the (Fig. 8).
Installation/removal of the
front caster wheels/lock
The stroller frame is equipped with two front
rotating wheels that can rotate 360° around
the vertical axis. To mount the front wheels,
simply insert the wheel axle in the proper place
on the frame and push it upwards to lock the
system (Fig. 9). To remove the wheel, press the
internal button beneath the wheel lock, and pull
the wheel on yourself (Fig. 9). To fix/release the
rotating wheel system, turn the wheel lock over
the wheel (Fig. 10).
Brake
The stroller is equipped with brakes that lock
the rear wheels. Push down on the pedal
that locks the rear wheels to stop the stroller
(Fig. 11). Turn back the pedal to the starting
position to continue moving.
Shock absorption
The stroller has a spring damping system and
the Anti-shock system that ensures the comfort
of your baby.
Carrycot
Before using — unfold the carrycot with special
lugs. Pull them in the appropriate directions
and lock them in special places (Fig. 12). To
mount the carrycot, place it in the adapter
compartment located on the inside of the frame
till you hear a proper sound (Fig. 13). To remove
EN