- 1 -
INSTRUCTION MANUAL
Aqua Dry Gun
ADG-1BV
Incorrect operation or mishandling can cause serious bodily injury, death, fire,
explosion, finish problem and spray gun malfunction.
Pay special attention to section shown with the symbols below.
The safety precautions in this instruction manual describe the minimum necessary
information. Be sure to follow national and local regulations on fire prevention,
electricity and safety as well as your own corporate regulations.
This symbol indicates that a potentially hazardous situation
may result in serious injury or death if not followed.
This symbol indicates that a potentially hazardous situation
may result in minor or moderate injury or damage.
■
Important specifications
Max. Air Pressure
0.68MPa / 6.8bar / (98psI)
Noise Level
78 dB(A)
Operating Air Temperature
5 - 43°C (41 - 110°F)
■
Main specifications
Model
Standard Inlet Air Pressure
MPa (bar/psi)
Air Consumption
L/min (cfm)
Remarks
ADG-1BV
0.1 (1.0/14)
390 (13.8)
■
Safety precautions
1. Be sure to tighten all connection, If not, it can cause problem and injury.
2. Be sure to use spray gun at less than the maximum working pressure.
3. Wear hearing protection. Noise level can exceed more than 78dB(A) depending on use and working
conditions.
4. Wear eye protection.
5. Never use near/toward a person or animals. High air pressure can cause serious injury.
6. Use only with pressured air. Never use any other gas. It can cause difficult breathing, serious bodily
injury, fire and explosion.
7. If operation appears incorrect, immediately stop operation and find the cause. Never use until the
problem has been solved.
8. Repair or replace worn or damaged parts immediately. Always use ANEST IWATA replacement parts.
1. Put pressured air through and blow air toward a rug before using when first time use after purchasing.
Anti-corrosive oil is applied inside gun. If not, it can cause finish problem.
2. Use clean air filtered through a dryer and a filter finer. If not, it can cause finish problem.
■
Maintenance and inspection
1. Always release air pressure before cleaning, disassembly or service.
2. Never soak whole gun into solvent for cleaning. It can cause gun malfunction.
3. Never disassemble spray gun without receiving proper education and training.
This instruction manual contains IMPORTANT
WARNINGS, CAUTIONS and INSTRUCTIONS.
Equipment in this instruction manual is exclusively
for coating purposes. Do not use for other
purposes.
The operator shall fully understand the
requirements stated within the instruction manual
including important warnings, cautions and
operation and correct handling.
Read and understand the instruction manual before
use and retain for reference.
和文取説は裏面にあります
