7. Software Version (Display only)
8. Error Code History (Displays if there are present error codes or up to 10 previous error codes). Water Heater Display
will show -- if there are no error codes.
To change the Maximum Setpoint Limit (Max Setpoint) for the temperature setpoint:
Step 1: In service mode press the “Select” button until “Max Setpoint” is displayed.
SELECT
SET
Status
idle
Operational
Soft
SELECT
SET
Status
°F
idle
Max
Operational
Setpoint
SELECT
SET
Status
idle
Operational
No current error codes
Setting the water temperature to the maximum set point can result in scalding hot water delivered to the taps. It
is highly recommended that the maximum setpoint be adjusted to the lowest temperature possible for the needs of
the installation. See following section to change the maximum setpoint limit (max setpoint). Make sure the water
heater control display is not in a public area that can result in the temperature settings being improperly adjusted.
See previous warning on scalds and an ASSE approved mixing valve.
WARNING
13
Ecoflo E864_ADENDA_MAR 2012 itempOCT12 16/10/12 11:07 Page 13
Summary of Contents for CSC39
Page 2: ... 2 ...