4. Commissioning
Manual
MF0145AXA.doc
Manual for ION-M17P/19P Advanced
Page 21
4.2. Electrical Installation
4.2.1. Health and Safety for Electrical Installation
Read and observe chapter
1.2 Health and Safety
.
Danger: Electrical hazard. Danger of death or fatal injury from electrical
current. Obey all general and regional installation and safety regulations
relating to work on high voltage installations, as well as regulations
covering correct use of tools and personal protective equipment.
4.2.2. Property Damage Warnings for Electrical Installation
1.
Attention:
It is compulsory to ground (earth) the unit before connecting the
power supply. Grounding bolts are provided on the cabinet to connect the
ground-bonding cable.
2.
Attention:
If the mains connector of the Remote Unit is not easily accessible, a
disconnect device in the mains power circuit must be provided within easy reach.
3.
Attention:
A connection of the mains supply to a power socket requires the
power socket to be nearby the Remote Unit.
4.
Attention:
Before connecting or disconnecting the mains connector at the
Remote Unit, ensure that mains power supply is disconnected.
5.
Attention:
Make sure that an appropriate circuit breaker acting as a disconnect
device (as required by IEC/EN60950-1) and an overcurrent limiting device are
connected between mains power and the Remote Unit.
6.
Attention:
Incorrectly wired
connections
can destroy electrical and electronic
components.
7.
Notice:
Although the Remote Unit is internally protected against overvoltage, it is
strongly recommended to ground (earth) the antenna cables close to the antenna
connectors of the Remote Unit for protection against atmospheric discharge. In
areas with strong lightning, it is strongly recommended to install additional
lightning protection.
8.
Notice:
To avoid corrosion at the connectors caused by electrochemical
processes, the material of the cable connectors must not cause a higher potential
difference than 0.6 V (see electrochemical contact series).
9.
Notice:
Use an appropriate torque wrench for the coupling torque of the 4.3-10
type connector: 5 N-m (44 in lb) with 22 mm (7/8) in opening.
Do NOT use your hands or any other tool (e.g. a pair of pliers). This might
cause damage to the connector and lead to a malfunction of the Remote Unit.
