6
7) Secure the collar in place by
tightening the clamp locking screw.
8) Connect the power connector to
the plug attached to the heater
head. Secure the plug and socket
with the clamp provided. Note the
markings.
9) The heater head can be fitted to
the upper pole by aligning the
locations and then secure using the
two 8mm screws.
10) IMPORTANT: Set the height of
the heater head above 1.8m before
fixing the supply cable to the base.
IMPORTANT: The cable clamps
must be released before increasing
the height of the heater head.
The power cord must be secured to
the base using the clamps and
screws provided.
Operating the appliance
Caution: Although the appliance is
shower proof, do not use the
appliance when it is raining or in
wet conditions.
Connect the power cable to a 13
amp earthed supply that is
located in a safe, dry area.
Ensure that the plug and power
socket are accessible when the
appliance is operating. This allows
the plug to be removed or the
power socket switched off if
required
The two switches on the heater
head are used to control the
three heat setting.
(I) = 900W
(II) = 1200W
(I & II) = 2100W
