Andover Controls DCX 250, Installation Manual

Page: 14 / 29

Hardware Installation
6 DCX 250 Installation Guide
Laying Out the Site Setup
You may want to draw a map of where you plan to put each controller
and store it in a notebook.
Find the tag attached to each controller that gives the number of the con-
troller. Before you remove any tags, be sure the tag has all of the
following information on it:
• Model number.
• Serial number.
• Location of the DCX 250 controller.
• Communications port the Infinet connects to on the Infinity CX 9000.
(The DCX 250 installed inside the Infinity CX 9000 cabinet is
automatically on COMM2.)
Figure 1 shows what the tag looks like.
Then collect the tags. You will need to know where your controllers are
located when you later assign a name to each controller and each input
and output.
Figure 1. Tag That Identifies the Controller
Model DCX 250
S/N 09878
Volts 24 VAC 50/60 Hz
Amps .55 A
Output Contacts
Volts XXXXX
Amps XXXXX Date XXX
S/N 09878
Location Room 10
DCX 250 Comm Port 2
ANDOVER CONTROLS
Andover Controls Corp.
Andover, MA 01810 USA
Energy Management
Equipment
Tear
Here
U
L

You May
Add as
Reminders
www.PDF-Zoo.com