4
3. The another clip is installed in the same way.
*Install main device: Loosen the small thumbscrews on the optical bracket. Then slide the optical stack
in to the ring of the optical bracket. Finally tighten the thumbscrews to hold the optical stack in place.
If done correctly,
you should be able to not just turn the focus controller of the optical stack freely,
but also freely adjust the monitor,
the angle between the base and the optical bracket,
while the
rest of microscope remains in place. If you have any question or problem for assembly,
please
contact us as soon as possible,
so you won’t damage the device during assembly.
*Connect the power supply: connect the microscope and the power supply with the switch cable. (See
Figure 6)
（
Figure 6 Connect
）
（
Figure7 Remote buttons
）
